Hi, needing some advice..
My CV joint rubber's torn the other day and needs replacement. Leaked a bit of grease on the driveway. Been driving around since and didnt have time to get this fixed yet.
Question - should I assume that the 'Front ball joints' and 'Lower Ball joint" also need replacing? What are the chances they're still okay, what are the risks of not replacing?
tHanks
Herman
CV Joint rubbers replacement
- Rigger
- Low Range 4WD
- Posts: 188
- Joined: Mon Dec 07, 2015 1:03 pm
- Town: George
- Vehicle: Toyota Hilux 3.0 S/C 4x4
- Real Name: Martiens
Re: CV Joint rubbers replacement
You should not assume anything. Jack it up and check the upper and lower ball joints with a tyre lever for play. There should be none. You can also check the control arm bushes. If all are good then just replace the CV boot rubbers.
- pietpetoors
- Moderator
- Posts: 10650
- Joined: Thu May 17, 2007 9:12 pm
- Town: Langebaan
- Vehicle: 2.7 Hilux 4x4 DC
- Real Name: Pieter
- Club VHF Licence: X27
- Contact:
Re: CV Joint rubbers replacement
Rather check and make sure because maybe they are still good. Unless, if they are not too expensive, replace them because whoever fits the cv joint rubbers will have to loosen them anyway. Labour is very expensive and the more you can do at the same time the better.
Tip: Do not postpone too long, dust goes into the CV and if you use it like that for too long you can loose a CV joint which is far more expensive replacing only the rubber. And stay away from those cheap universal rubbers which are cut open on the side which you just glue on, designed for people who are too lazy to remove the sideshaft.
Tip: Do not postpone too long, dust goes into the CV and if you use it like that for too long you can loose a CV joint which is far more expensive replacing only the rubber. And stay away from those cheap universal rubbers which are cut open on the side which you just glue on, designed for people who are too lazy to remove the sideshaft.
Only Dead Fish Go With The Flow!
1999 Hilux 2.7i 4x4 Raider DC with 3.4 Prado V6. Rear diff-lock, Bull Bar and rock sliders, 31" Cooper ST Maxx, Snorkel, Alu-Canopy, VHF Motorolla radio, West Coast Rust, Mikem Suspension, Ball Joint Spacers in front and Mikem extended shackles at the rear, 25watt LED Spots
1999 Hilux 2.7i 4x4 Raider DC with 3.4 Prado V6. Rear diff-lock, Bull Bar and rock sliders, 31" Cooper ST Maxx, Snorkel, Alu-Canopy, VHF Motorolla radio, West Coast Rust, Mikem Suspension, Ball Joint Spacers in front and Mikem extended shackles at the rear, 25watt LED Spots
- herman916
- High Range 2WD
- Posts: 12
- Joined: Thu Jan 06, 2011 9:08 pm
- Town: Somerset West
- Vehicle: KZ-TE DC 4x4
- Real Name: Herman
Re: CV Joint rubbers replacement
Noted, thanks for the advice!
- Rigger
- Low Range 4WD
- Posts: 188
- Joined: Mon Dec 07, 2015 1:03 pm
- Town: George
- Vehicle: Toyota Hilux 3.0 S/C 4x4
- Real Name: Martiens
Re: CV Joint rubbers replacement
If you do replace ball joints, please replace with OEM parts. Its going to be more expensive but pirate part cannot be trusted especially with suspensions. Saw a photo of a Prado the other day where the lower ball joint fell out while driving due to cheap parts used.
- pietpetoors
- Moderator
- Posts: 10650
- Joined: Thu May 17, 2007 9:12 pm
- Town: Langebaan
- Vehicle: 2.7 Hilux 4x4 DC
- Real Name: Pieter
- Club VHF Licence: X27
- Contact:
Re: CV Joint rubbers replacement
That is a common Prado 90 problem (presume it is Prado 90), even happens with worn out OEM ball jointsSaw a photo of a Prado the other day where the lower ball joint fell out
Only Dead Fish Go With The Flow!
1999 Hilux 2.7i 4x4 Raider DC with 3.4 Prado V6. Rear diff-lock, Bull Bar and rock sliders, 31" Cooper ST Maxx, Snorkel, Alu-Canopy, VHF Motorolla radio, West Coast Rust, Mikem Suspension, Ball Joint Spacers in front and Mikem extended shackles at the rear, 25watt LED Spots
1999 Hilux 2.7i 4x4 Raider DC with 3.4 Prado V6. Rear diff-lock, Bull Bar and rock sliders, 31" Cooper ST Maxx, Snorkel, Alu-Canopy, VHF Motorolla radio, West Coast Rust, Mikem Suspension, Ball Joint Spacers in front and Mikem extended shackles at the rear, 25watt LED Spots
- Rigger
- Low Range 4WD
- Posts: 188
- Joined: Mon Dec 07, 2015 1:03 pm
- Town: George
- Vehicle: Toyota Hilux 3.0 S/C 4x4
- Real Name: Martiens
Re: CV Joint rubbers replacement
Yes, it was indeed a 90 but the guy replaced ball joints 3 months prior to the incident with pirate parts.pietpetoors wrote: ↑Sun Feb 25, 2018 12:22 pmThat is a common Prado 90 problem (presume it is Prado 90), even happens with worn out OEM ball jointsSaw a photo of a Prado the other day where the lower ball joint fell out