A-Pilar Grab handles for 2.7 and KZTE Hilux
Posted: Tue Jun 28, 2016 8:35 pm
Not sure how many of you know that there are threaded holes in the A-pilar of the 1999-2005 Hilux for grab handles.
Even the plastic covers has marks to show where one have to cut it should you install grab handles.
I could not get the correct grab handles, thus I took some from a 1999 Prado 90 for my Hilux.
They are shorter than the ones that should go into the Hilux.
The holes in the A-pilar is 200mm apart, maybe somebody know which other Toyota's grab handles will fit.
Remove this cover to see the holes These are the Grab handle Holes I first fitted it on the top hole, but then I could not drill a proper bottom hole for the Rivnut.
So I had to fasten it using the bottom hole in the pilar and mark the hole to be drilled at the top hole of the handle. I used a 6mm Rivnut for the top bolt. And this is the final result. Fitted on both sides.
Even the plastic covers has marks to show where one have to cut it should you install grab handles.
I could not get the correct grab handles, thus I took some from a 1999 Prado 90 for my Hilux.
They are shorter than the ones that should go into the Hilux.
The holes in the A-pilar is 200mm apart, maybe somebody know which other Toyota's grab handles will fit.
Remove this cover to see the holes These are the Grab handle Holes I first fitted it on the top hole, but then I could not drill a proper bottom hole for the Rivnut.
So I had to fasten it using the bottom hole in the pilar and mark the hole to be drilled at the top hole of the handle. I used a 6mm Rivnut for the top bolt. And this is the final result. Fitted on both sides.