Hilux 4x4 Forum

Start with the Basics.

Bleed the system completely.
Check for leaks.
Check the rear brake shoes
Check front brake pads
Check front calipers securing bolts, they might be loose.
Check rear brake shoes configuration, ie look if you see any springs adjuster or parts missing.

Well it's from this Forum that we all learned and still will learn how to look after our 4x4's.

HAPPY BIRTHDAYYYYYYYYY!!!!!!!!!!!!!!!!!!!!!!!!!!!

The H4 LED globes works quite great with the Revo. If you wanted more light at night it will make a huge difference. The lenses have no influence.

Net 'n vraag. Het jy al jou ignition switch vervang?

As jou sleutel kan uitkom terwyl die engin loop dan is die barrel en switch uitgewerk. Daai kan sports maak.

Dont move the spring mounts forward. Your Hilux is std.

Those blades should measure about 1100mm in lenght in the front if my memory serve me correct. Looks if you have the rear blades there.

Kyk in die dizzy cap. Haal hom af heeltemal.

Myne se eletrodes was lekker aangepak, 1ste keer toe ek gekyk het was dit laat middag en ek dink ek het dit toe gemis.

Maak hulle skoon totdat daar geen aanpaksel meer is nie dan sal dit al klaar help.

Those look if they a bit too short. The shackle position is not right. Ask Darrell for the flat u Bolt in the back that the rod can move past.

Its a thing of Toyota, none of the lights are usually the same as its counterpart(ie. Fortuner)

Does your headlights have the H4 Globes in at the moment?

The problem with the bottom feed is you still get muck to your pump. These tanks are old so it loose the lining inside. Best is to get an inline filter between the tank and pump. This will stop the muck from getting to the pump. Another is to change the feed pipe diameter to at least 10mm inside to ...

Hi

My blue light did not work before, my globe is toast in the instrument panel. Let me check if I can get it going.

Its a plug and play unit. Only thing you might turn the base plate relative to the Led's to have the same alignment as the original globe. Its in the instructions how to do it.

Electrical Diagram for Hilux 2006 up Vigo's

I think this can help if you work through the Manual. Its full Detail.

http://www.tuningconcepts.com/Cars/Hilu ... iagram.pdf

Normally on a SFA you don't have dims, you have candles. Well Xenons was a improvement but after the H4 Led upgrade it went to far better. I checked the Headlight inserts and found that here and there some on the silver lining was pealing. I replaced both headlight inserts too. Brights 1st and dims ...

Jy kan seker kry by Toyota maar dit gaan te veel kos om te regverdig.

Ek net geleer as jy die 4Y(Chinees) koop dat jy net na 1000km die headboute net moet torque.

Al die 4Y's wat inkom is maar Chinees.

Ek het my engin gekoop by Engin Den in Pta Wes so 5 jaar gelede. Die het tans 102 000km gedoen en is nog lank nie klaar.

Carbs veral die Nikki gaan mens net by Toyota kry, al die ander is Chinees. Toyota is net duur.

Yes the new Hilux do have the Intelligent Alternator in With the National Luna solenoid ground the negative wire(Thin black wire) to the chassis. Not to the battery. This will give of resistance and let the Ecu think there will be load on the battery. Not sure if it solve the HCDP problem too. Do th...

That's just the plastic cap that is cracked. If the needle in the front still sticks out and it give a good cone if its energized its fine.

Those caps if your patient Toyota can order. Use part number 23291-73010(called a injector isolator). The Landcruiser 80 3F motor share the same cap.

Spot on Stef. The simple way is to take a M8 Bolt. Give it white plumbers tape and turn it in. Yes there was a blank off plate for the Egr but its not serious. That hole go direct into the head and oil move quite a lot there. Water in the system can be from the chain chowing into the recess of the w...

The hole behind the manifold is it the intake manifold? if it is its simple fix. white tape and m8 bolt should sort it out, they forgot to put it in again.

You don't use a head gasket again. You fit a new one.

Riaan come pass sometime that I can look at it. Sounds like a steering problem.

Mooi Man.

Very Nice George.

your 5th gear broke 2 or more teeth unfortunately.

I check for you tonite if I got one.

Cracked head is rare.

Your becoming an Expert!!

Willem ek doen die ene om ondervinding te kry. Ek sit al op die projek waar ek seker so 1uur in 'n aand tyd spandeer op die oomblik. Did nou te se as daar tyd is. Ek log al 392 ure op hom. Beste van alles die bakkie het die ou 1UZ ingehad. Sou vining wees maar toe nou nie. Ek stel voor praat met Hop...

AS jy die 3UZ ingebou het sal die ou 1UZ en nuwer 1UZ vvti makliker pas. Ek doen dit omgekeerd, vanaf ou 1UZ na 3UZ.

Ja ek weet van die parte kan uitgeruil word maar die feit bly staan dat die 3UZ wyer is as die ou 1UZ. Ek is lank besig met die omruil van die 1UZ na die 3UZ, Dit is nie 'n direk uitruil nie. Die bakkie het 'n 1UZ ingehad, sou dit dan nie net uit trek en insit gewees het nie? Ek skuif die Stuurbox, ...

Non 1UZ Lexus measure +/- 620mm head to head.

3UZ Lexus Measure +/- 680mm head to head.

Vra vir die 1UZ-FE VVti, nuwer genearasie.

Gaan liewers vir die nuwe 1UZ. Makliker om in te sit. Die 3UZ is baie wyd. Daar gaan baie goed geskuif moet word.

Ek stel voor 'n body lift van 30mm gaan die fitment ook makliker maak.

This is a Vigo V6 plate I done 2 months ago. Ordered Toyota and got this. Not the 1st time.

Aisin is the real group that makes Toyota parts. But now, Sachs makes these kits under the Aisin brand.

Irony to it.

Then if you buy at Toyota a clutch kit you get LUK...seldom Aisin.

We going to go replace the input shaft and seal too. Bearing cage broke too.

Graphite grease should work perfect.

Die naweek goed ondersoek gedoen op die samestelling op die conversion. Ek mooi die bellhousing gemeet, die was mooi reguit maar het iets gehad wat gepla het. Aan die linkerkant was daar 'n lang dun kraak. Sou nie die gesien het as ek dit nie skoongemaak het nie. Toe haal die boks uit. Wel toe die b...

Mohamed its on the rear leaf springs that you can re grease the hanger bushes from time to time. Sometimes grease the inter leaf liners too between the blades.

Guys we looking for a Wl25 bellhousing to Hilux Sfa gearbox for Nathan. Phoned Gilo and they don't make those. Or is it another one they use.

Inputs please.

Nope. Water usually cause the motor to stop working. Or check the rubber hose on the unit. it can perish or pull off at some point.

Ek het nog altyd bo in en onder uit bedraad.

One can strip, clean the actuator. Usually the actuator.

Who got Radio's that works with these Mic's?

Nathan did you manage?

Acmc - 012 327 0040.

Bietjie agtergrond;

viewtopic.php?f=98&t=26418&p=315488&hil ... er#p315488" onclick="window.open(this.href);return false;

Thanks By the looks of it the clutch slave cylinder sits screw on the bellhousing. This can break the fork over a long time. Then the bellhousing have to be checked, I might be wrong but looks if it thicker at the top than at the bottom, might be the photo. Let me show you on my pic. A is wider than...

Dit sal interesant wees.

Hi,

What setup do you have on the Hilux?

Ie is it standard? Any Aftermarket bumpers, extra permanent weight?

What part numbers was used?

Ag nee Willem. Dis nie lekker nie.

I like to help. Lets see the setup.

Nathan do you have photos of the Bellhousing, fork etc.?

The pilot bearing ok in the crank?

Is the adaptor plate scew? If its out scew by 2mm the clutch wont last.

Die prys vir links en regs is R1078.

Ome se bladveer bushes is altyd almal geel. Dan ook die voorste ene voor die agterwiel het gewoonlik ook 'n sleeve in.

As die bushes swart is dan is dit die std rubber bushes.

Een aan die linkerkant is rubber, regs is 'n Ome polyurethane bush. Let wel die ene is 7 jaar oud.

Mooi so. Maak nie saak of jy sag word nie. Party van die Bakkies net te goed om te laat gaan.

Jip, net soos jy se.

MS Grease. CV grease.

Red Grease wear out too fast.

Ek vra dat iemand my help. Draai eers die kante in sodat die splitpin kan net net ingaan, haal uit die splitpin. Die person binne beweeg die stuurwiel links na regs heeltyd. Ek stel die een kant in totdat ek sien dat die pin het speeling van so 2 tot 3mm. Dieselfde vir die anderkant. Die idee is om ...

Net onthou as mens nie so elke jaar en 'n half die goed ghries met Graphite ghries sal geen bush tipe hou nie. Dan ook ghries hulle net op die shackle pen. Bietjie lanks die kant. Dan ook,as daar air helpers in is en daar is nie vrag op nie, maak seker dat die air helpers tot 0.8 bar gepomp is. Al b...

Search found 1955 matches